banner
Home » NEWS » Content
Product Categories

Laser Marking Processing Of The Flexible

- May 18, 2017 -

(1) the laser itself is a relatively simple and easy to control the device, if it produces the beam into a very fine light beam, you can cut; defocus a little can be welded; and then defocus a little, can be heat treatment.

(2) the use of laser processing, not only processing speed, high efficiency, low cost, and to avoid the mold or tool replacement, shorten the production preparation time cycle. Easy to achieve continuous processing, laser beam transposition time is short, improve the production efficiency. Can be a variety of workpiece alternately installed. When a workpiece is machined, the finished parts can be removed and the workpiece to be machined is installed to achieve parallel machining, reduce the installation time and increase the laser processing time.